Điểm nổi bật
| FINDING CIRCUIT BREAKER | |
 Use
the tip of the Sniffer to scan the circuit breakers. Please note that
the Sniffer is designed to be held vertically for the vertical circuit
breakers and horizontally for the horizontal circuit breakers. |
|
| MAKE SURE ALL THE CIRCUIT BREAKERS ARE ON |
|
| For example, start scanning from the top left row, then go down etc. |
|
| But you can scan the breakers in any order. While you are scanning, observe the bar-graph and listen to the buzzer. |
|
| FINDING EARTH FAULT |
|
| To
find an earth fault or the trace faulty wire, you must connect the
transmitter in serie with the fault. For example, if you have a short
between Line and Earth, but you don't know where the short is. |
|
| Connect
the Transmitter, using and adaptor, in series, in the line. If the
Protection device trips, then you will have to bypass the protection
device for the duration of this test. Use the optional leads for this
use. |
| The 188FFF is a Fuse and Fault Finder which comprises of two parts : The Receiver and the Transmitter |
| The
Transitter draws a current from the mains supply circuit to whcih it is
connected to the Signal Current from the Tx is at about 10 kHz. The
Transmitter is powered by the mains and requires no batteries |
| The
10kHz signal current generated by the Transmitter is then searched
(sniffed) by the Receiver to detect the Fuse, Circuit Breaker or the
faulty circuit |
| The
Receiver is a tuned circuit which has it's center frequency tuned to
about 10kHz. The sensor is located in the tip of the Receiver |
| The amplitude of the received signal is shown on a bar-graph type LEDs |
| The more LEDs ON, the stronger the signal. The Receiver uses on 9V battery |
0
